EMRFD Chapter 4 Errata.
  (31July09, 01Aug09, 8May11)

p4.2, left column, 4.2 inches down from text top:  replace "system in the Figure" with "system in Fig 4.1"   (9Dec03)    It should be Fig 4.1.     (17 Apr 9)  

p4.7, middle col, 0.3 inches down from text top:   replace "it's own" with "its own." (31July09)

p4.13,  1st col., 1 inch down from top.  Replace "autotransformer" with "transformer"   (3Dec03)

p4.15, Fig 4.28.   The inductor should be 57 nH.    This should be replaced in both the figure and in the caption.   The caption should also say that the inductor is formed with 3 inches of wire with 5 turns (not 3) wound on the 6-32 screw. (10Nov05)    The L value was corrected in the 3rd printing, but the wire length was not.  (17April9)                  

p4.15, Fig 4.27.   Caption:  Remove the second sentence, for a constant Lm is NOT a good general model for all crystals.  (31July09)  

p4.24, right column, bottom of page:  replace the sentence "Assume, for example, that 1-Hz changes the reference at the detector." with  "Assume that the reference at the phase detector changes by 1 Hz."   (9Dec03)   OK, the new sentence is there, but now we need to change the "1H2" to "1 Hz"  .   (17April9)

p4.25, Fig. 4.47.  The resistors, top to bottom, are 1K, 10K, and 4.7K. (24Feb03)   

p4.25, Fig 4.47.   The 74HC193 is shown as having pins 5 and 14 connected to +5 volts.   It should be pins 5 and 16 to 5 volts.  (8May11)


p4.28, left column, 1.3 inches up from text bottom:   replace "into the later category" with "into the latter "category   (9Dec03)